TT-12W LED Light not working
Sometimes a disruption of power to the TT-12W can cause the LED Light to stop functioning. To potentially correct the issue please try the following:
1. Unplug the camera's power adapter from the wall/power socket, then unplug the other end from the camera. Also make sure the LED light switch is set to OFF.
2. Hold the camera's power button down for 10 seconds to drain all power from the unit.
3. First plug the power adapter into the wall/power socket, then plug the other end back into the camera.
4. Wait a few minutes for the camera to reinitialize itself (solid red power LED). Turn on the camera, and then test the LED again.
If the LED still will not power on, please submit a support ticket: https://support.elmousa.com/portal/en/newticket
Related Articles
TT-12W Blinking red light firmware update
This guide if for cameras with a serial number of 4800000 or higher. If you have a lower serial number, please submit a support ticket. This guide is intended for advanced users only. Please review troubleshooting tips before trying. If your TT-12W ...ELMO Camera LED light issues
If the LED light on your ELMO is no longer functioning properly, please contact our support team for repair service. To prevent damaging the unit, please do not try to repair the LED yourself. Click here to contact usTT-12W Camera will not turn on and the power LED is flashing red
Please try the following troubleshooting steps. 1. Change the power adapter with a known working one. 2. Unplug the unit, hold the power button for 10 seconds to drain residual power, and then plug it back in + wait 1 hour. 3. For cameras with a ...TT-12W Product Support
Having trouble setting up your TT-12W document camera? Use this article to troubleshoot common issues and get answers to your questions! Troubleshooting Problem: Camera not recognized / No image from camera Solution: Change cable and/or input port. ...TT-12G Overview