TT-12G HDMI Input to USB passthrough
TT-12G HDMI Input to USB passthrough troubleshooting
If you are having trouble using the HDMI Input over USB feature, please see below for troubleshooting tips. Before starting, please make sure HDMI passthrough is enabled on your TT-12G to use this feature. A guide to setting up passthrough can be ...
TT-12G HDMI over USB feature
Please note that the settings menus can only be accessed when your camera is connected to a display (TV, Projector, or Monitor) and not a computer until the HDMI over USB feature is enabled. Please see Connecting your Camera to a TV or Monitor or ...
Setting up HDMI or VGA Passthrough
1. Identify the video input ports available on your display device (Projector, Monitor, IFP) and compare them to the video out ports on your ELMO camera. The ports will be labeled as 'OUT' on your camera. Please note that the ports available will ...
HDMI Passthrough issues with MacBooks
When setting up HDMI passthrough using a MacBook you may experience some connectivity issues. Please try the following to correct the problems. 1. Open the MacBook's display settings and try setting the resolution lower. For best results, please ...
TT-12i and TT-12iD USB Mode
The TT-12i and TT-12iD must have the USB Mode Setting set to “UVC” to be recognized natively by a computer Operating System. During this process ensure the USB cable is NOT connected to the camera as it may cause the setting change to fail. 1. ...